Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CAMs does not work in a cluster


Tell  me please, I have two Cams worked in a cluster on version 4.1.8, after  updating to version 4.8.0, interfaces, synchronization can not see each  other and the tab failover each CAM neighbor is not active (dead)

Sincerely, Alexander

1 ACCEPTED SOLUTION

Accepted Solutions

Re: CAMs does not work in a cluster

Alexander,

Check your certificates. Install the same certificate/private key pair on both CAMs.

More details here:

https://supportforums.cisco.com/docs/DOC-12609

Also other certificate related documents are available here:

https://supportforums.cisco.com/community/netpro/security/others?view=documents

HTH,

Faisal

--

If you find this post helpful, please rate so others can find the answer easily

3 REPLIES

Re: CAMs does not work in a cluster

Alexander,

Check your certificates. Install the same certificate/private key pair on both CAMs.

More details here:

https://supportforums.cisco.com/docs/DOC-12609

Also other certificate related documents are available here:

https://supportforums.cisco.com/community/netpro/security/others?view=documents

HTH,

Faisal

--

If you find this post helpful, please rate so others can find the answer easily

New Member

Re: CAMs does not work in a cluster

Faisal,

Thank you very much, it worked for your advice!

New Member

Re: CAMs does not work in a cluster

I could see two possibilities:

a) Certificates issues, as Failsal said

b) Check by using "vi" that the insterfaces that you use for heart beat still the same as 4.1.8

Juan Huicab Internetworking juan.huicab@nextiraone.com.mx T 52 (81) 1001 8000 E 8015 C 52 (81) 1077 2435 San Pedro Garza García, N. L. México www.nextiraone.com.mx
339
Views
0
Helpful
3
Replies