Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can a failover bundle PIX515UR can work as to different primary Active PIX

I am having PIX515UR bundle and single pIX 515. This two pIX are for two different networks of customer. The PIX 515FO-bundle is configured in failover mode. while another PIX - 515 is running as a standalone.

The single 515 has failed , and till the time i get it replaced , i want to use one of the PIX from failover bundle.

I tried it to use , but its not comming up.

I used command no failover and tried to make it active.

it worked fine , but after 24 hours it got reset once again..........

is it possible to use PIX in failover bundle as to different PIX ?????

1 REPLY
New Member

Re: Can a failover bundle PIX515UR can work as to different prim

If you use a FO PIX without an Active then it will reset every 24 hours if there was no primary when it first booted up.

This is to stop violation of the license agreement.

85
Views
0
Helpful
1
Replies