Re: Can any one help me,Cisco Guard always be in disconnect stat
You can configure the interactive status for a specific policy, or any part of it, and decide whether or not that part of the policy should produce recommendations and pending dynamic filters. Configuring the interactive status of a policy gives you control and enables you to improve how policies adapt to traffic flows. The Interactive protect mode?Creates dynamic filters during an attack but does not activate them. Instead, the Guard groups the dynamic filters as recommended actions for you to review and decide whether to accept, ignore, or direct these recommendations to automatic activation.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...