Can I carry out source and destination static NAT on a PIX515E

[jam1977]

I have been asked to carry out NAT on a PIX515E. The requirement is to NAT both source and destination IP address. All destination addresses will be static 1 to 1 mappings whereas the source may be either static or a pool.

Is this possible and how do I configure this?

[r-simpson]

Yes, You can do this starting from version 6.2. More details here http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a0080094aad.shtml#topic12