I have a IDS which is 3.0 and I am not getting alams on the CSPM, I get only route up or down and nofification , CAn I use IDS event viewer 4.1 to see the events from the IDS 4210, Do I need to configure anything on the IDS extra, This is UNIX base,
I used the Event viewer on IDS 4210 with 4.0 version and its working fine, I get the events.
You would need to use IEV 3.x to see events from 3.x sensors.
IEV 4.x only works with 4.x sensors.
If you have some sensors running 3.x and some sensors running 4.x, then you will need to load IEV 3.x on one machine, and IEV 4.x on a separate machine. The 2 versions of IEV can not be run on the same machine. NOTE: IEV can also not be run on the same machine as CSPM.
Uninstall IEV and use Cisco Threat Response - it allows you to manage alarms from Cisco IDS 4.x,3.x, and RealSecure NetworkSensors from one console. Like CSPM, it too can not run on the same box as IEV - both use mysql. Right now Cisco Threat Response is free.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...