11-10-2009 11:26 PM - edited 02-21-2020 03:47 AM
Dear All,
I had ASA5510 and i want to opent ASA 5510 by ASDM ,
So i can open it but when i click configuration it tell that:
you are authorized to access only home and monitoring Views
How can i have authorized to change something on ASA 5510.
Best Regards,
rechard
11-11-2009 08:25 AM
Rechard,
A username with level 15 privileges needs to be configured. Do you have telnet or SSH access to the device? If so you can create a username similar to the following;
username mmessier password GoRaNgErS privilege 15
Hope it helps you out.
11-11-2009 06:33 PM
Dear collin,
Thank for you advise!!!
i'm not clear about user privilege 15, so what does it mean?
How can i do if i would like to some user can access ASDM (Read-write) and other user can access (Read-only) i mean can View and monitor?
I mean that:
1- username A passowrd A (Full access ASDM)
2- username B password B (View and Monitor only)
which command that i do ?
Best Regards,
Rechard_hk
11-12-2009 07:32 AM
Here's a link how to set it up.
http://www.fir3net.com/Firewalls/PIX-Cisco/pix-asdm-read-only-account.html
There are 16 levels of authorization, 0-15. 15 has the highest privilege level and 0 the least. These are not in the config until you configure different levels. What we do is take the commands that will allow read-only and move them down in privilege level (level 5 in the link). Then we create a username at privilege level 5. They can now use the commands we moved down to their level. Users at a level also have access to commands below them.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: