Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can't access internal net from VPN client

We have Win2K network, PIX, then 2620 router to T1. VPN clients connect, but then can't access our internal net (192.168.1.0). The config for the PIX has NAT... the VPN client gets addresses from 192.168.2.x. Is there a ROUTE statement I'm missing here?

Thanx

2 REPLIES
New Member

Re: Can't access internal net from VPN client

Check this two statements.

access-list # permit ip 192.168.1.0 255.255.255.0 192.168.2.0 255.255.255.0

nat (inside) 0 access-list #

New Member

Re: Can't access internal net from VPN client

On top of what Abdul has suggested make sure you have an access-list enable on the outside interface which allows tcp/ip to your 192.168.2.0 /24 network, i.e

access-list # permit ip 192.168.2.0 255.255.255.0 192.168.1.0 255.255.2550

access-group # in interface outside

96
Views
0
Helpful
2
Replies