when I add pix to a network,it complains "your ip address can't be the same to your gateway address" when I set its outside interface ip address using 'dis conver interface settings',but I can manually set it .
what is wrong ?
for example, when I add pix1 to network 172.16.3.0,at the outside interface ip address tab,it discover "172.16.3.2" ip address for this interface automaticly,but if i press "next" button,the error messages will appear.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...