Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can't Add SNMP Host - ASA/PIX

Hello,

Has anyone ever seen the following message when attempting to add an SNMP host on an ASA/PIX..??

"IP and subnetmask form invalid pair indicating broadcast or network address"

Here is what I am trying to enter...

"snmp-server host OUTSIDE 1.x.x.43 community xxx"

I already have the following config, but I can not add .43...

"snmp-server host OUTSIDE 1.1.1.42 community STRING"

Thanks!!

Lee

5 REPLIES
New Member

Re: Can't Add SNMP Host - ASA/PIX

never seen that b4, what version of code are you running?

New Member

Re: Can't Add SNMP Host - ASA/PIX

I'm running 7.0(4). I still cannot figure out why I cannot add this host.

Thanks for your help!

New Member

Re: Can't Add SNMP Host - ASA/PIX

Lee,

There is a bug in some versions of ASA, Bug ID CSCsc37492.

I found a work around by increasing the subnet mask size on the interface then adding the SNMP host then changing the subnet size back.

However, this config will only remain untin the ASA is rebooted. But it should give you enough time to monitor the ASA until you can upgrade the software.

Andrew

New Member

Re: Can't Add SNMP Host - ASA/PIX

Thanks for your reply. I was not aware of this bug. I will indeed upgrade.

New Member

Re: Can't Add SNMP Host - ASA/PIX

Im attemp commands with same problem;

command--> snmp-server host inside 10.250.2.63 community securezone

display--> Error : IP and subnetmask form invalid pair indicating broadcast or network address

Display agrees with a network mask /26, but the network 10.250.2.0 has chewed /24, something absurd! since the connectivity between host and pix are perfect, from host I even leave to Internet by pix and can administer pix. With IP,64 it happens the same.

491
Views
0
Helpful
5
Replies
CreatePlease login to create content