Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Can't get traffic through RA-VPN

ASA 5510, 7.2.3.

VPN-conf done via wizard. AAA ok and everything looks fine, tunnel is up but can't get any traffic through. Saw some "no translation group for 192.168.1.90" in the ASDM-log wich seems to be related... Saw some other threads about this issue but can't pin point the problem in my setup.

Please help, see attached config.

1 REPLY
Cisco Employee

Re: Can't get traffic through RA-VPN

I see a "vlan1_nat0_outbound" ACL Configured on the ASA but not applied anywhere. You need to apply it, something like.

nat (native-vlan) 0 vlan1_nat0_outbound

Regards,

Arul

** Please rate helpful posts **

104
Views
0
Helpful
1
Replies
CreatePlease to create content