10-19-2006 06:10 PM - edited 03-09-2019 04:36 PM
Hi all,
I use Catalyst 6513 with a module FWSM. I install more policy on FWSM but I can't do. I don't know why. When I install policy, I see a sentence:
Direct failover lan unit [primary or secondary] command will be ignored because MC control only active unit
HTTP error! Make sure the username and password are correct. Otherwise check the network connection status.
deploy result: 0 commands executed, 1 error(s)!
Deploy task failed!
If you know the cause, please answer me early.
Thank you very much.
Duy Khang
10-19-2006 09:57 PM
Kind of strange message. The failover commands are part of the system context which is not haldled/administrated with VMS. Usually you just push a policy on a FW context (Virtual firewall).
Do you use a single context mode or multiple context mode ?
What exactly have you changed in the policy ?
sincerely
Patrick
10-19-2006 10:07 PM
Dear Patrick,
I only add some service in policy such as adding service http_proxy to rule. I don't change any thing.
10-19-2006 11:10 PM
Do you use a single context mode or multiple context mode ?
10-19-2006 11:20 PM
I don't understand the question. I use FWSM (version 2.3), you can tell more clearly
10-22-2006 07:01 PM
Dear sir,
I don't know if Cisco VSM isn't compatible with java?
Please answer me FWSM v2.3 will be compatible with the version of java?
Thank you very much
I am looking forwarding your answer
Duy Khang
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: