can't install policy on module FWSM (in Catalyst 6513)

[mylove142]

Hi all,

I use Catalyst 6513 with a module FWSM. I install more policy on FWSM but I can't do. I don't know why. When I install policy, I see a sentence:

Direct failover lan unit [primary or secondary] command will be ignored because MC control only active unit

HTTP error! Make sure the username and password are correct. Otherwise check the network connection status.

deploy result: 0 commands executed, 1 error(s)!

Deploy task failed!

If you know the cause, please answer me early.

Thank you very much.

Duy Khang

[Patrick Iseli]

Kind of strange message. The failover commands are part of the system context which is not haldled/administrated with VMS. Usually you just push a policy on a FW context (Virtual firewall).

Do you use a single context mode or multiple context mode ?

What exactly have you changed in the policy ?

sincerely

Patrick

[mylove142]

Dear Patrick,

I only add some service in policy such as adding service http_proxy to rule. I don't change any thing.

[Patrick Iseli]

Do you use a single context mode or multiple context mode ?

[mylove142]

I don't understand the question. I use FWSM (version 2.3), you can tell more clearly

[mylove142]

Dear sir,

I don't know if Cisco VSM isn't compatible with java?

Please answer me FWSM v2.3 will be compatible with the version of java?

Thank you very much

I am looking forwarding your answer

Duy Khang