Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can't map a drive using VPN client

Using client 3.5.2. I am behind FW. I can connect to the remote VPN, can ping the machine by IP and name once connected. I CANNOT map the drive I want access to. What is the problem? HELP!!!!

3 REPLIES
e.l
New Member

Re: Can't map a drive using VPN client

Do you use NETBIOS name or IP address when mapping the drive ? If you can not mapping using NETBIOS name, try using IP address. If it success , than the problem may be caused by a NETBIOS name resolution issue. Regards,

New Member

Re: Can't map a drive using VPN client

Thanx so much for your response. HOWEVER, I cannot map the drive by its IP either. I'm stumped!

New Member

Re: Can't map a drive using VPN client

I had the same problem.

In my case, the solution was to enter my username and password when mapping the drive (click on "Connect using a different user name")

120
Views
0
Helpful
3
Replies
CreatePlease login to create content