Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cannot set sensor IP address

Hello,

Despite the fact that I have run through the sysconfig-sensor setup and enable the ip address on the 4200 IDS sensor - I cannot get it to retain the ip address.

The ip address just comes up as 0.0.0.0

Anybody had this problem before?

3 REPLIES
Cisco Employee

Re: Cannot set sensor IP address

Does this happen even after rebooting the sensor to save the changes?

What version is this sensor on? Maybe, it will help to reflash the ids using the recovery CD.

Thanks,

Yatin

New Member

Re: Cannot set sensor IP address

Tried rebooting and ensured that there was no other ip address in the network.

The only way I could for the network up was to change the address through "ifconfig" and then doing an "up" on the interface. But this was at OS level.

I rebuilt the ids and everything worked 100%

STRANGE!!!

Silver

Re: Cannot set sensor IP address

Hi,

Please make sure that the same address doesn't exist in the network. May be a ip duplication issue. A reboot may help as mentioned by the previous post. Thanks,

Mynul

97
Views
0
Helpful
3
Replies
CreatePlease to create content