Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

cant access internal server, Ipconfig show no gateway

Hi all

I am back to where i am again

after configuration of the spilt tunnel command on my ASA, i was able to access Internet using my own connection from home after dialing in with the VPN client, but now i cant seem to access the company internal server

The ipconfig show the gateway to be blank.

a ping to the internal server show the destination unreachable. Please help.

isakmp policy 1 authentication pre-share

isakmp policy 1 encryption 3des

isakmp policy 1 hash sha

isakmp policy 1 group 2

isakmp policy 1 lifetime 43200

isakmp enable outside

ip local pool vpnpool 192.168.4.10-192.168.4.245

username test password test

crypto ipsec transform set FirstSet esp-3des esp-md5-hmac

tunnel-group nslgroup type ipsec-ra

tunnel-group nslgroup general-attributes

address-pool vpnpool

tunnel-group nslgroup ipsec-attributes

pre-shared-key test

crypto dynamic-map dyn1 1 set transform-set nslSet

crypto dynamic-map dyn1 1 set reverse-route

crypto map mymap 1 ipsec-isakmp dynamic dyn1

crypto map mymap interface outside

access-list nonat extended permit ip 172.21.0.0 255.255.0.0 192.168.4.0 255.255.255.0

nat (Inside) 0 access-list nonat

vpngroup nslgroup split-tunnel 180

access-list 180 permit ip host 192.168.4.0 host 192.168.4.245

2 REPLIES
Silver

Re: cant access internal server, Ipconfig show no gateway

If you are using "reverse-route", then this route must be redistributed into the routing protocol that you are using internally.

New Member

Re: cant access internal server, Ipconfig show no gateway

Hi There

Thank you for your input

Can i do without the reserve-route command then? what other workaround do i have?

130
Views
0
Helpful
2
Replies