I recently set up an Active/Standby failover configuration with 2 sub-interfaces configured on my g0/0 interface (g0/0.1 and g0/0.2) for some reason I cant ping either of these from my testing server (when the server is on the correct network and subnet to test the interface)? I am not sure whats going on... I included a print out of most of my current configuration.
no ip address
ip address 66.38.x.x 255.255.255.224 standby 66.38.x.x
ip address 64.187.x.x 255.255.255.224 standby 64.187.x.x
ip address 10.10.x.x 255.255.255.0 standby 10.10.x.x
ip address 192.168.x.x 255.255.255.0 standby 192.168.x.x
description LAN/STATE Failover Interface
description STATE Failover Interface
ip address 192.168.x.x 255.255.255.0
clock timezone EST -5
clock summer-time EDT recurring
pager lines 24
logging monitor debugging
logging asdm informational
mtu Outside1 1500
mtu Outside2 1500
mtu DMZ 1500
mtu Private 1500
failover lan unit primary
failover lan interface FoInt GigabitEthernet0/3
failover replication http
failover link FoInt GigabitEthernet0/3
failover interface ip FoInt 192.168.x.x 255.255.255.0 standby 192.168.x.x
I am using a Dell 2624 switch for testing.... do I need to set another sub-interface to act as a trunk line for the g0/0 interface then? Also just wondering if that switch will work with Sub-Interfaces.... or do I have to re-think my setup?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...