Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CAS and CAM command reference

HI,

I am using latest CAM 4.7.2 and same CAS versiion .

Can anyone suggest a link to command reference for 4.7.2 .

Only a few commands are found in the config guides

Always using the GUI is not very helpful.

regards

Raj

2 REPLIES

Re: CAS and CAM command reference

Raj,

Clean access is different in this regard. The command line is used only to do the initial config and the bulk of configs are done through the GUI only. Data is all kept in the database to which the GUI talks, so there are no command line tools to configure the CCA per se.

HTH,

Faisal

New Member

Re: CAS and CAM command reference

Hi,

I am not talking of command line tools.

I am saying when we troubleshoot NAC , say in CAM I am checking for a particcular file , I should know where it is located and we can use command line instead of GUI as TAC does .

Say suppose I want to restart CAM , in command reference , it should show init6 and init 0 in command referance.

Or do a debug in command line , take a capture stuff like that , or edit the interface parameters , but not from the setup menu

Where do i find the docuementation related to that .

reg

Raj

401
Views
0
Helpful
2
Replies