Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CAS and exempt device

Excuse my naivety, but I have the following problem. I have a CAS and a controlled port X; I add the mac address learnt by port X to the exempt list on the CAS. I restart the device attached to the port, but the port is then forced into the authentication VLAN defined by the port control on the CAS. Is this expected behaviour? As I was expecting the device to be placed onto the access vlan.

1 REPLY

Re: CAS and exempt device

From the CAM v4 Manager manual:

Filter lists (configured under Device Management > Filters) can be set by MAC, IP or subnet, and can auto-set role assignment. Filters allow users (or devices) to bypass both authentication and Clean Access certification (posture assessment).

The Exempt list is set by MAC address (under Device Management > Clean Access > Certified Devices > Add Exempt Device) and allows users to bypass Clean Access certification (posture assessment) only.

204
Views
0
Helpful
1
Replies
CreatePlease login to create content