Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CAS behind firewall issue

Hi,

I have a a setup with one CAM, one CAS and a firewall between them. There is also NAT in place.

I changed the requiered things like in the configuration guide.

After the changes, I'm able to connect the CAM with the CAS. But after the a reboot of the CAS the connection is broken and cannot be "repaired" because the CAM tries to connect to the original IP and not to the NAT IP which it was connected to earlier. I can only "repair" the connection when I delete the CAS on the CAM an reinitiate the connection.

Any ideas?

regards Dirk

regards, Dirk (Please rate if helpful)
2 REPLIES
New Member

Re: CAS behind firewall issue

When using NAT on the trusted (eth0) side of the CAS, the CAS remains manageable by the CAM by passing the NATed service IP address to the CAM using the "autoconnect" feature.

New Member

Re: CAS behind firewall issue

hi

"When using NAT on the trusted (eth0) side of the CAS, the CAS remains manageable by the CAM by passing the NATed service IP address to the CAM using the "autoconnect" feature."

how to activate "autoconnect" feature

best regards

123
Views
0
Helpful
2
Replies
CreatePlease login to create content