Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Catalyst 1900 missing CLI

Hi gentlemen,

We have two similar Catalyst 1900 switches with v9.00.04 firmware. One of them, right after telnet connection established, switches to Menu-driven interface. I need to use Command Line Interface. Menu mode and management through browser don't give me choice to use restricted-static entries in MAC Address Table (to define which ports may connect to the specific port).

How can I get to it?

Thank you

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Catalyst 1900 missing CLI

You will need to run the IOS Enterprise edition in order to have CLI on the switch.

1 REPLY
New Member

Re: Catalyst 1900 missing CLI

You will need to run the IOS Enterprise edition in order to have CLI on the switch.

151
Views
5
Helpful
1
Replies
CreatePlease login to create content