Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Catalyst 2960 Mode Button

Hello,

Can anyone tell me a method of disabling the Mode button function on a Catalyst 2960 to stop it rebooting the switch after being held for 10 secs? Even with a full config on the switch, the 'reset' function still appears to over-ride the config and clear/reload the switch.

Is there any way of disabling this function in software?

Many thanks

Charlie Read

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Catalyst 2960 Mode Button

Try the following command: no setup express

See the following link for more detail on the command.

http://www.cisco.com/en/US/products/hw/switches/ps628/products_command_reference_chapter09186a00801a6c4a.html#3549999

Hope this helps.

Steve

2 REPLIES
Silver

Re: Catalyst 2960 Mode Button

Try the following command: no setup express

See the following link for more detail on the command.

http://www.cisco.com/en/US/products/hw/switches/ps628/products_command_reference_chapter09186a00801a6c4a.html#3549999

Hope this helps.

Steve

New Member

Re: Catalyst 2960 Mode Button

Steve,

Many thanks, that sorted it out - much obliged.

Cheers

Charlie

1076
Views
5
Helpful
2
Replies
CreatePlease to create content