Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCA does not appear to be managing switch ports in OOB Virtual Gateway mode

I'm trying to setup a lab to demo CCA for CCA using the OOB Virtual Gateway deployment. Followed all the instructions in the manuals (v4) but they do seem a bit light on with the details for the switch config. I have setup the CAM to manage the LAB switch, but when I connect a laptop to a managed port it gets no challenge, just gets DHCP address passes straight through.

Debugging on the switch shows no SNMP traffic generated from anything. Community strings are correct, CAM can configure the switch, there are no exemptions in the profiles of the CAM, VLAN mappings are all OK. What else should I be looking at???

2 REPLIES

Re: CCA does not appear to be managing switch ports in OOB Virtu

somthing along the lines of:

int f5/0/24

description Clean Access port

switchport mode access

snmp trap mac-notification added

snmp trap mac-notification removed

snmp-server enable traps MAC-Notification

snmp-server community snmp-community

snmp-server host CAM_SERVICE_IP snmp-community

And set the port to be managed on the CAM.

New Member

Re: CCA does not appear to be managing switch ports in OOB Virtu

Hi,

How did you manage to get the eth1 to work. I get "HOSTFLAPPING" errors in the core switch when I connect the eth1 port to the switch. I have configured trunks on the core switch to the eth0 & eth1 ports of the CAS.

111
Views
0
Helpful
2
Replies
CreatePlease login to create content