Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Change MTU on one ipsec tunnel PIX-TO-PIX

Hello,

i have one pix acting as hub and three pix as spoke. On one link i have pppoe on the outside interface. The ipsec tunnel get an MTU of 1492 while the other end at the spoke have an MTU of 1500 for this tunnel. Anyone who knows if there's a way to change the MTU only on this particular tunnel on the hub pix to 1492 without changing the interface MTU.

2 REPLIES
Community Member

Re: Change MTU on one ipsec tunnel PIX-TO-PIX

I think it's not possible. If you have mtu/fragment problems on the spoke with DSL, i suggest you to configure

sysopt connection tcpmss 1300

on the spoke. That will likely solve your problems, since udp packets are rearly larger than that size.

A_a

Community Member

Re: Change MTU on one ipsec tunnel PIX-TO-PIX

Ok,

thanks for the tip.

Tony

189
Views
0
Helpful
2
Replies
CreatePlease to create content