Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Checkpoint Firewall & configuring 802.1q trunking in 6513 SW CAT IOS

Dear All,

I was just trying to implement one checkpoint suggested solution where VLAN is created in firewall and one can mapped existing Layer 2 VLAN to this VLAN which is connected to one of the switch port configured for 802.1Q trunking. Right now I have made the port as 802.1Q trunk but if I am connecting any PC to any other port in that switch which is mapped to existing VLAN config. in firewall that PC is not able to connect. I think something I am doing wrong in case of trunking port and tunneling port. Please let me know how to go about configuring 802.1Q in a layer 2 switch using cat IOS

2 REPLIES
Silver

Re: Checkpoint Firewall & configuring 802.1q trunking in 6513 SW

New Member

Re: Checkpoint Firewall & configuring 802.1q trunking in 6513 SW

Dear Edgar,

If possible let me know your email id so that I can mail you the design which I am trying to implement here. The above site will not be of much help as I have gone through those lot of time.

With bestregards,

Mani

675
Views
0
Helpful
2
Replies