Checkpoint Firewall & configuring 802.1q trunking in 6513 SW CAT IOS

[m.pandey]

Dear All,

I was just trying to implement one checkpoint suggested solution where VLAN is created in firewall and one can mapped existing Layer 2 VLAN to this VLAN which is connected to one of the switch port configured for 802.1Q trunking. Right now I have made the port as 802.1Q trunk but if I am connecting any PC to any other port in that switch which is mapped to existing VLAN config. in firewall that PC is not able to connect. I think something I am doing wrong in case of trunking port and tunneling port. Please let me know how to go about configuring 802.1Q in a layer 2 switch using cat IOS

[ebreniz]

Check this link .

http://www.cisco.com/en/US/tech/tk389/tk390/technologies_configuration_example09186a0080094637.shtml

[m.pandey]

Dear Edgar,

If possible let me know your email id so that I can mail you the design which I am trying to implement here. The above site will not be of much help as I have gone through those lot of time.

With bestregards,

Mani