Choosing IP Pool based on NAS-Identifier in Cisco Radius Server

[f.millan]

Hi,

We have a configuration with 2 NAS and one Cisco Radius server, with one VPN5008 in the middle. We would like to provide some redundancy/load sharing to such configuration, i.e., one user goes to 1 nas, next to the other, etc. Such configuration was working before when there weren't radius server and the ip address were allocated via a DHCP server, with two differents Pools, one for each nas.

The problem is that it seems that the Radius server doesn't support to choose the ip pools via the NAS-Identifier. If we choose to set only one ip pool, there is no way to know to which nas we need to route the traffic. Any ideas?

thanks in advance.

Francisco

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.