Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Cisco 1750 VPN router to perform NAT

(Note: This message was posted as part of the "Ask the Expert" Event on IPsec and Client Software that took place August 28 - September 4. Feel free to respond to or form discussions around this question)

Posted by pphilosophe - TECHNICAL & COMMUNICATIONS MGR, CINRAM INTERNATIONAL INC.

I am failing to logon a Remote Office VPN Windows 95 client to a NT environment. After careful analysis, I have discovered that the MS WINS is working successfully but is registering the source IP from the NetBIOS header instead of the NAT address. In other words, NAT is not translating the NetBIOS IP address. How can I configure a Cisco 1750 VPN router to perform NAT on the addresses in NetBIOS datagram headers coming from my Remote Office 1750?

  • Other Security Subjects
2 REPLIES
New Member

Re: Cisco 1750 VPN router to perform NAT

Your problem is IOS NAT doesn't support NetBios. NAT was designed for common Internet protocols such as HTTP and FTP. Why are you performing NAT on your tunnel traffic? Are both networks on the same segment? Finally, what are you trying to accomplish here?

New Member

Re: Cisco 1750 VPN router to perform NAT

Check out http://www.cisco.com/warp/public/701/60.html for a list of protocols IOS NAT supports

246
Views
0
Helpful
2
Replies
This widget could not be displayed.