Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 1811w

I would like to know if there is something I can do to allow wireless traffic to the local LAN.

My config is attached. i have Vlans 1-5, 1&2 are for the lan, 3-5 are for wireless. I cannot access resources on the LAN with either.

5 REPLIES

Re: Cisco 1811w

Edgar,

Enter the below under the main lan interface:-

bridge-group 1

no bridge-group 1 source-learning

bridge-group 1 spanning-disabled

HTH.

New Member

Re: Cisco 1811w

I apologize, I have since changed my config,hoping to correct the issue. I removed the bridging that was associated with it, but I still have the same issue.

New Member

Re: Cisco 1811w

Disregard,I figured it out.

I removed the deny ip any 10.10.1.0 0.0.0.255.

I do appreciate the help.

access-list 111 permit ip 10.10.1.0 0.0.0.15 host 10.10.1.1

access-list 111 permit ip any 10.10.1.0 0.0.0.255

access-list 111 permit ip 10.10.1.0 0.0.0.15 any

access-list 111 permit udp any any eq bootpc

access-list 111 permit udp any any eq bootps

access-list 111 deny ip any any

Re: Cisco 1811w

You have removed ALL the wireless config?

New Member

Re: Cisco 1811w

No, the wireless is still configured, I just removed the bridging, and the network performs great. The appropiate Vlans are segmented and protected, Thanks for you help .

128
Views
5
Helpful
5
Replies