Can you do a capture to see traffic on your access attempt? Set the logging level one your router to see what is being blocked. On your ACL, make sure you put the final deny statement in with the 'log' option, to see what is being blocked. Did you tie the ACL to the inside or outside interface? Are you inspecting inbound our outbound on the interface?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...