Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 678, DSL, VPN and NetScreen

Desperation and Frustration are setting in..

I am trying to use Cisco 678 with NetScreen VPN client.

I can access and ping all servers if I dial up my ISP. However, If I use the 678 via DSL and VPN, I can ping my companys router but not any of the servers. I can't access any of the servers. I have read various techniques about opening ports and setting NAT. And have had no luck in implementing them. Can this be done and if so how?

TIA

1 REPLY
Cisco Employee

Re: Cisco 678, DSL, VPN and NetScreen

Hi,

Just make sure that you have the Routing from the Servers setup properly and try doing a traceroute from these Servers to see where they are sending the packets which should go through the tunnel.

Regards,

Aamir

89
Views
0
Helpful
1
Replies