Cisco 678, DSL, VPN and NetScreen

[bdsmith]

Desperation and Frustration are setting in..

I am trying to use Cisco 678 with NetScreen VPN client.

I can access and ping all servers if I dial up my ISP. However, If I use the 678 via DSL and VPN, I can ping my companys router but not any of the servers. I can't access any of the servers. I have read various techniques about opening ports and setting NAT. And have had no luck in implementing them. Can this be done and if so how?

TIA

[awaheed]

Hi,

Just make sure that you have the Routing from the Servers setup properly and try doing a traceroute from these Servers to see where they are sending the packets which should go through the tunnel.

Regards,

Aamir