Cisco Support Community
Community Member

Cisco 831 to PIX 515 EZVPN

I have a PIX 515 running 6.2.2 configured to allow both a lan to lan tunnel and Cisco VPN clients to attach. Both scenario's work fine. The customer is bringing up a remote so we want to use the 831 for this new site in client mode. I have used the EZVPN configuration guide and both the PIX and the 831 match the guide, yet we cannot get the 831 to attach. The 831 was originially running 12.3.8T and I upgraded to 12.3.14.T6. This did not help. The upgrade did add the xauth userid mode interactive command which we did not want to use. This message constantly scrolls on the console: %CRYPTO-6-EZVPN_CONNECTION_DOWN: (Client) User= Group=wv

agvpn Client_public_addr=x.x.x.x Server_public_addr=x.x.x.x

I have attached configurations for both devices and debugs from the 831.

I have verified that the shared key is correct.

Any help would be appreciated!



Community Member

Re: Cisco 831 to PIX 515 EZVPN

Did you ever get this reolved? I have a similar issue but it is 831 to 831.

Community Member

Re: Cisco 831 to PIX 515 EZVPN

yes, see attached config. We also had to updgrade the PIX to 7.x to allow hairpin connections back out the outside interface.

CreatePlease to create content