Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco 837 - No PDM web console anymore

We have put our own configuration on our Cisco 837 router. We are using a quite recent IOS and before we put our configure on the router we could get on the web console, but now we can't. hav we removed some important settings? I have enable IP http server and IP http secure-server and it load a rubbish website with the following displayed:

Show diagnostic log - display the diagnostic log.

Monitor the router - HTML access to the command line interface at level 0,1,2,3,4,5,6,7,8,9,10,11,12,13,14,15

Show tech-support - display information commonly needed by tech support.

Extended Ping - Send extended ping commands.

How can I get the PDM back?

1 REPLY
Silver

Re: Cisco 837 - No PDM web console anymore

copying of Image from one PIX to another is concerened. It is not possible until or unlesss you have the PIX configured in the failover mode.

Once you get the access to the Cisco softwares then this time try upgrading the PDM to the latest Version and then check it out.

163
Views
0
Helpful
1
Replies
CreatePlease to create content