Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco ASA ASA5510-SEC-BUN-K9 2GE 3FE, 2GE not showing

Hi,

we have bought the cisco part ASA5510-SEC-BUN-K9. According to the description, it has 2Ge and 3 FE ports but its showing me 5FE ports and doesn't have any GE port. How could i have 2 GE on this platform? is any special configuration/licence needs to be implemented.

Here is a show version

Result of the command: "sh ver"

Cisco Adaptive Security Appliance Software Version 8.0(4)
Device Manager Version 6.1(3)

Compiled on Thu 07-Aug-08 20:53 by builders
System image file is "disk0:/asa804-k8.bin"
Config file at boot was "startup-config"

Firewall up 331 days 20 hours

Hardware:   ASA5510, 256 MB RAM, CPU Pentium 4 Celeron 1600 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash M50FW080 @ 0xffe00000, 1024KB

Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0)
                             Boot microcode   :  CN1000-MC-BOOT-2.00
                             SSL/IKE microcode:  CNLite-MC-SSLm-PLUS-2.03
                             IPSec microcode  :  CNlite-MC-IPSECm-MAIN-2.05
0: Ext: Ethernet0/0         : address is 001f.9f3c.71a8, irq 9
1: Ext: Ethernet0/1         : address is 001f.9f3c.71a9, irq 9
2: Ext: Ethernet0/2         : address is 001f.9fe3c.71aa, irq 9
3: Ext: Ethernet0/3         : address is 001f.9f3c.71ab, irq 9
4: Ext: Management0/0       : address is 001f.9f3c.71a7, irq 11
5: Int: Not used            : irq 11
6: Int: Not used            : irq 5

Licensed features for this platform:
Maximum Physical Interfaces  : Unlimited
Maximum VLANs                : 100      
Inside Hosts                 : Unlimited
Failover                     : Active/Active
VPN-DES                      : Enabled  
VPN-3DES-AES                 : Enabled  
Security Contexts            : 2        
GTP/GPRS                     : Disabled 
VPN Peers                    : 250      
WebVPN Peers                 : 2        
AnyConnect for Mobile        : Disabled 
AnyConnect for Linksys phone : Disabled 
Advanced Endpoint Assessment : Disabled 
UC Proxy Sessions            : 2       

This platform has an ASA 5510 Security Plus license.

Serial Number: **********

Running Activation Key: ******************************** Configuration register is 0x1

1 REPLY

Re: Cisco ASA ASA5510-SEC-BUN-K9 2GE 3FE, 2GE not showing

ethernet0/0  and ethernet0/1  are gig ready, if you go to interface mode on interfaces 0/0 and 0/1  you can specify speed


place a question mark

asa(config)interface ethernet0/0
asa(config-if)speed ?

you shoudl be able to see 10/100/1000 speed options

Rgds

1887
Views
0
Helpful
1
Replies
CreatePlease to create content