I can connect to my companies VPN. I am not able to browse anything on the network. I am able to ping everything on our internal network. I am new at configuring PIX VPN and I need to know what possiblly I have left out. I have done the following commands:
I can ping WINS server and PDC when using the VPN. They are the same server. On the WINS server I show 2 failed attempts.Should I be using split-tunneling? I don't have a sniffer so I can't do that part. I am going to a PIX class in a month. Do i need to put in any NAT translations or use an access-list?
Are you using the cisco vpn client 3.5. if so you need to go to "Options | Windows Logon Properties" and check "Enable start before logon". this will launch the VPN client before you login allowing you to login to the private network after a VPN connection is established.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...