There is no specific sample configuration on setting up a IPSEC Tunnel between a Cisco Router and Netscreen. But, you use below example, which discusses configuring IPSEC Tunnel between a Pix and Netscreen. This should give an idea of what is to be configured on the Netscreen.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...