i would implement a solution with a NAS with a PRI access and depending from with user acessing the nas the authentification local on ACS2.6 or with NT i will assign IP adress from a pool (this is possible i know it) but after i would like to route this user only to a specific netowrk ( i will have 3 differnet departement behind this NAS and 3 different subnet )
Re: cisco secure 2.6 selecting destination per user ?
This can certainly be done, and it works very well. You will end up configuring per-user access lists. However, if you could indicate whether you will use radius or tacacs+ that would be helpful; the explanation/instructions for each are somewhat lengthy. I will check back and reply. Thanks!
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...