I recently upgraded our Cisco Secure AS to ver 3.2 but have encountered problems. I have users who authenticate to a checkpoint NG FP3 firewall, which passes the authentication to cisco secure (radius) and cisco secure authenticates against a Novell NDS DB. This all works with 3.0(1) but with 3.2 it fails with the message "External DB user invalid or bad password", even though i know the credentials passed are correct. I had to roll back to allow users to connect.
Has anyone got an any ideas on this or seen it before?
I remember reading somewhere that a user must preface their username with the domain backslash to get authenticated. Please see if this might be the cause of the problem. Another possibility is bug CSCdu63791 'T+ enable partially broken for external db users'.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...