I need a configuration for a 1750 router to allow access from a Cisco VPN software client running on a W2k pc. The 1750 is connected directly to the internet on a serial port and into the network via ethernet. The 1750 is running NAT from the ethernet(inside) network to the Internet(outside). The NAT pool is a range of 66.X.X.X addresses but the serial interface is statically addressed with 172.16.X.X A pool of inside addresses is available for the VPN clients. The pc has a static address to connect it to a wireless router. The wireless router obtains its address via DHCP from the cable modem connected to an ISP.