I have a few customers who have the Linksys BEFW11S4 wireless router. They are able to authenticate through the wireless, but not traffic is passed. The user then plugs into the 4 port switch on the router and they authenticate and traffic begins to flow. I have had success with another customer who uses a Seimens DSL router with the Linksys WAP11 Access point and has had success using the Cisco VPN Client across the wireless. Does anyone know of the settings on the Linksys router that need to be changed to allow VPN Traffic to pass across the wireless network?
Also, when you upgrade the firmware for the device ( make sure you get the right firmware update pre ver 2, or after ver 2 models arent compatible ). Then enable IPSEC pass-thru and or port forward tcp/udp 10000 to a specific internal IP... (TCP or UDP depending on your conectrator allow ruleset).
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...