access-list inside_outbound_nat0_acl permit ip interface inside interface outside
access-list outside_cryptomap_20 permit ip interface inside interface outside
That is, only encrypt traffic that has a source address of your PIX inside interface, going to the PIX outside interface, this is NOT what you want. You have to specify the traffic as coming FROM the PIX inside subnet (10.0.0.0/8) going to the subnet behind the Sonicwall. The above two access-lists should end up looking like:
access-list inside_outbound_nat0_acl permit ip 10.0.0.0 255.0.0.0
access-list outside_cryptomap_20 permit ip 10.0.0.0 255.0.0.0
Feel free to make his change via the command-line, then load up PDM again and you'll see where these should have been specified.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...