Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CiscoSecure VPN Client 1.1 with PIX problems routing

Hello

I've got a cisco Secure VPN Client1.1 trying to connect to a pix via IPSec. Basically this is an existing config which I'm trying to optimize. There are two internal networks on the inside of the pix. Is there any way to set up the VPN Client 1.1 to be able to use both internal networks through the VPN tunnel? How is this routing performed? Thanks...Could someone direct me to some docs on this client. Thanks again.

  • Other Security Subjects
1 REPLY
New Member

Re: CiscoSecure VPN Client 1.1 with PIX problems routing

Hi there,

I think you can do it according to this document:

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csvpnc/csvpnsg/icover.htm

best wishes,

Nikhil

86
Views
0
Helpful
1
Replies