Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Clear Access-List hitcnt

I think I am overlooking the answear. What is the command to reset the hitcnt to 0 on an access-list on a Pix firewall to get a point of reference?

We have a 520 Pix.

5 REPLIES
Bronze

Re: Clear Access-List hitcnt

Go into config mode and try this...

clear access-list count

Hope that helps.

New Member

Re: Clear Access-List hitcnt

That is what I thought it was, but our PIX does not reconize that command. I made sure I was in configuration mode when I typed it. We have IOS version 6.0(1) if that makes a difference.

Bronze

Re: Clear Access-List hitcnt

Does not look like it was released fully with no bugs until 6.2(1)

New Member

Re: Clear Access-List hitcnt

If it's critical to you to know the counts and you need them cleared you can try reloaded the pix(restarting) but this will take it down for a few min while it boots.

New Member

Re: Clear Access-List hitcnt

I ended up creating a duplicate access-list and reassociating it with the interface.

385
Views
5
Helpful
5
Replies