Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

clear counters on PIX Firewall Interfaces

How can I clear counters on my PIX Firewall 515E ver 6.3(4). There are alot of input errors on my inside interface. Please advice.

7 REPLIES
Hall of Fame Super Blue

Re: clear counters on PIX Firewall Interfaces

pix(config)# clear counters

or if you want to clear only a particular interface

pix(config)# clear counters

Jon

New Member

Re: clear counters on PIX Firewall Interfaces

It doesn't work on PIX FIREWALL 515E version 6.3(4)

Hall of Fame Super Blue

Re: clear counters on PIX Firewall Interfaces

Bernadette

Apologies, it is not "clear counters" it is "clear counter".

You also need to make sure you are doing this in config mode -

http://www.cisco.com/en/US/docs/security/pix/pix63/command/reference/c.html#wp1091147

Jon

Re: clear counters on PIX Firewall Interfaces

As Jon indicated, you need to be in config mode,

try - pix(config)#clear interface to reset all interface counters.

for especific interface

(config)#clear interface

(config)#clear interface ethernet0

etc..

Rgds

Jorge

New Member

Re: clear counters on PIX Firewall Interfaces

it doesn't work.

Re: clear counters on PIX Firewall Interfaces

did you go into config mode and enter the command?

e.i

pix>enable

pix#config

pix(config)#clear interface

Bronze

Re: clear counters on PIX Firewall Interfaces

"clear interface" but that might not correct the issue, when you get CRS errors that indicates that there is an issue with cables or problems with speed or duplex of the neighbors devices.

4719
Views
0
Helpful
7
Replies
CreatePlease to create content