Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Clear XLATE on PIX 6.3(4)

On a PIX 515 with a 6.3(4) OS:

I removed a NAT Static and added a PAT static with the same local address but a different global address. I then did a "CLEAR XLATE LOCAL XXX" where XXX is the local address in the Static. "Show XLATE" displayed the new mapping, but I was unable to actually connect to the resource until doing a "CLEAR XLATE" (with no qualifiers).

Am I missing something important here? Why should it be necessary to clear more than the one existing NAT mapping for the local address?

2 REPLIES
Gold

Re: Clear XLATE on PIX 6.3(4)

would it be possible that the the "mapped ip" in the new pat static statement has already been mapped to some other host?

so by clearing the xlate with the "real ip" only, it wouldn't map as the "mapped ip" is already in use.

New Member

Re: Clear XLATE on PIX 6.3(4)

No. The new new IP and port were not already assigned. In fact, a show XLATE revealed that the new mapping was in the XLATE table and there were incomming "hits" showing in the access-list.

Any ideas would be greatly appreciated.

256
Views
0
Helpful
2
Replies