Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Client to spoke remote access vpn config problem

Hi

My name is Ram, i am configuring client to spoke remote access vpn configuration but I am able to connect to hub not to spoke. The network connectivity as follows.

HUB l2lVPN Spoke

client-->pixfirewall---------ASA5510----->local lan

ver 7.0.1 ver 7.0.4 12

Client can able to connect to the local LAN with the pool of 10.10.10.0 255.255.255.0. I did the configuration and i am facing a problem to connect to from home to the spoke side LAN. Nat and crypto configuration is done in US end also. I am attaching the configuration and please help me to resolve this issue.

Thanks in advance.

Regards,

Ram

2 REPLIES

Re: Client to spoke remote access vpn config problem

You want to come in over a VPN client, then go back out the same interface on a L2L VPN?

This only becomes possible in v7.2, with the "same-security-traffic permit intra-interface" command.

Gold

Re: Client to spoke remote access vpn config problem

Ram,

Take a look/read and verify with the following document:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00805734ae.shtml

Hope this helps

238
Views
0
Helpful
2
Replies
CreatePlease to create content