im using the vpn client v 3.0 at my end to connect to my corp network. Im also behind a pix firewall and a cisco router. Im able to get authenticated, however, im not able to ping anywhere or access any servers at my company's network. If i remove my pix, im able to connect and access network resources. I've looked all over cisco site and did not find any info on how to make this possible. Here's my config. any suggestions.
Often times complex troubleshooting issues are best addressed in an interactive trouble-shooting session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...