Command for PAT

[sayeed]

I have PIX 501 , I have only one legal ip address , using global command everybody on the local network is browsing.

I forgot the command which will allow to map this legal ip address to inside ip address to a specific port.

If I have multiple legal address i could have used static (inside,outside) glip inside ip netmask command

but I have only one ip which I will have to use to map to port 25 for my inside exchange server.

Pls reply, bit urgent.

Regards,

Sayeed Alhajri.

[yusuff]

You have to use same static command, do a Port Redirection.

http://www.cisco.com/warp/public/707/28.html#port

or PATing for inside hosts to outside is;

nat (inside) 1 0 0

global (outside) 1 10.1.1.1 netmask 255.255.255.0

HTH

R/Yusuf