We are having a bit of a problem with our concentrator 3000.
Cisco Systems, Inc./VPN 3000 Concentrator Version 4.7.2.B Oct 04 2005 05:10:52
The concentraor is currently on our OSPF area 0.0.0.0
We would like to move it to a different area so that we can route summarise (There are about 1000 routes in area 0.0.0.0, and the concentrator can't handle it)
The problem is that when the concentrator won't let us change its OSPF area!
I have created the new area in Config/System/IP Routing/OSPF Areas
but when I try to remove the area 0.0.0.0 entry it fails with a
"Error deleting OSPF Area (Configuration Lock)" or a "Error deleting OSPF Area (General Error)" depending on how it's feeling.
I tried leaving the 0.0.0.0 area in there, and changed the router it is attached to to the new area, but the Concentrator does not recieve the new routes (I know the new area is working because I have another router recieving them OK)
When it doesn't work and I change it back, the concentrator just sits there with an empty routing table, and we are forced to reboot it before it recieves the area 0.0.0.0 routes again.
Can anyone please point me in the right direction?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...