Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

bma
New Member

concentrator 3005 cannot start

Hi

When I start concentrator 3005, concentrator get stuck on :

Boot-ROM Initializing... Boot configured 32Mb...

...

Loading image ..........

Verifying image checksum ...........

Active image loaded and verified...

Starting loaded image...

( Nothing more ....)

How do I set 3005 back to factory defaults, or how to fix it?

Thanks

ben

3 REPLIES
Cisco Employee

Re: concentrator 3005 cannot start

Get a console connection to the concentrator, and get a session up to the concentrator.

Cold boot the concentrator and then as it is booting up, hit ctrl g on your

keyboard and a recovery menu would be presented to allow you to boot to the

previous image without any config.

bma
New Member

Re: concentrator 3005 cannot start

Thanks.

after control-g, select option 6, or 2, still cannot boot, what need to do?

Ben

Cisco Employee

Re: concentrator 3005 cannot start

After doing a ctrl-g select option 5, toggle image so it would use the last known

good image. If it still doesn't boot, do a ctrl g again and select 6, to ignore config. See how you go, and if nothing works, log a case with TAC for further

troubleshooting.

85
Views
0
Helpful
3
Replies
CreatePlease login to create content